Mastodon · settings for Epiphone Les Paul Standard + Fender Frontman 10G
No effects needed for this part.
Bridge ProBucker into the Frontman's overdrive switch, gain high, bass trimmed slightly to avoid flub on the 6-inch speaker. Gets a buzzy approximation of a saturated JCM800 riff; a drive pedal would help most.
Less tight low end and less thick, midrange-rich saturation.
Workaround: Keep bass moderate and pick hard with the bridge pickup for definition.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom (1982) → BK Butler Tube Driver → Marshall JCM800 2203 100W, modded to 6550 power tubes → Marshall 4x12 (model not documented)
Riff itself is a short repeating figure, but the speed, triplet feel and consistent palm-mute attack take practice to lock in with the drums.
Every song already dialed in for the Fender Frontman 10G.
Fender Frontman 10G settings