Mastodon · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
Same amp family: JCM800 2203 on the High input, preamp pushed hard, mids kept present, bass firm. Bridge ProBucker with volume full. Without a Tube Driver, lean on preamp gain and amp volume for saturation and tightness.
Less saturation and looser low end without a front-end push.
Workaround: Max the preamp, raise the master, and cut bass slightly to tighten.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom (1982) → BK Butler Tube Driver → Marshall JCM800 2203 100W, modded to 6550 power tubes → Marshall 4x12 (model not documented)
Riff itself is a short repeating figure, but the speed, triplet feel and consistent palm-mute attack take practice to lock in with the drums.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings