Mastodon · settings for Epiphone Les Paul Standard + Marshall MG30GFX
At zero: FX Level · Reverb
No effects needed for this part.
Use the MG30GFX OD1 channel with the bridge ProBucker, mids kept forward and firm bass for a thick Marshall sludge crunch. The amp stays dry and there is no Tube Driver push, so the tightness comes from the gain staging and the EQ.
Without the boost, palm mutes are looser and the low end is less tight.
Workaround: Keep gain at 7 rather than maxing it, and trim the bass if chugs blur.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom (1982) → BK Butler Tube Driver → Marshall JCM800 2203 100W, modded to 6550 power tubes → Marshall 4x12 (model not documented)
Riff itself is a short repeating figure, but the speed, triplet feel and consistent palm-mute attack take practice to lock in with the drums.
Every song already dialed in for the Marshall MG30GFX.
Marshall MG30GFX settings