Masayoshi Takanaka · settings for Epiphone Les Paul Standard + Boss Katana Mini
Shortest practical time, low mix.
Clean Katana Mini voicing with neck ProBucker, coil-split for a glassier Strat-ish sparkle. Low gain, treble up, delay used as a short faux-ambience. Chorus and reverb must come from outside the amp.
Loses the signature shimmer and stereo width of the clean figures.
Workaround: Use coil-split neck pickup and gentle finger vibrato on sustained chords for movement; slight delay adds faint width.
Tone sounds dry and close instead of spacious 1978 fusion air.
Workaround: Run the Katana's delay very short and quiet as pseudo-ambience.
Percussive 16th-note chord cutting is less even in level.
Workaround: Control dynamics with consistent light right-hand picking.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Neck (or neck+middle on a Strat) for a round, warm clean
Yamaha SG or Fender Stratocaster → Compressor → Chorus → Roland JC-120 (clean channel) → JC-120 2x12 speakers → Studio plate/room reverb
Amp effects: reverb (JC-120 has spring reverb; set low if the amp assumption holds, otherwise ambience was studio-added), chorus (JC-120 has built-in stereo chorus/vibrato, the simplest route to his signature shimmer)
Notes are not fast, but the Latin syncopation, chord voicings and fully clean tone demand accurate right-hand control and muting.
Every song already dialed in for the Boss Katana Mini.
Boss Katana Mini settings