Masayoshi Takanaka · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
A JCM800 into a Les Paul is the opposite of a JC-120 clean, but low input, preamp around 3 and coil-split neck pickup gives a usable glassy clean. All chorus, reverb and compression must come from outside; none is owned.
Loses the signature shimmer and stereo width of the clean figures.
Workaround: Add light finger vibrato on sustained melody notes and let coil-split brightness carry the sparkle.
Dry and upfront; the spacious 1978 fusion tail is gone.
Workaround: Play in a live-sounding room and let notes ring slightly longer to imply space.
Percussive chord cutting is less even in dynamics.
Workaround: Use consistent light right-hand attack and palm muting to level the chords yourself.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Neck (or neck+middle on a Strat) for a round, warm clean
Yamaha SG or Fender Stratocaster → Compressor → Chorus → Roland JC-120 (clean channel) → JC-120 2x12 speakers → Studio plate/room reverb
Amp effects: reverb (JC-120 has spring reverb; set low if the amp assumption holds, otherwise ambience was studio-added), chorus (JC-120 has built-in stereo chorus/vibrato, the simplest route to his signature shimmer)
Notes are not fast, but the Latin syncopation, chord voicings and fully clean tone demand accurate right-hand control and muting.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings