Masayoshi Takanaka · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume
Clean Marshall voicing with neck ProBuckers rolled slightly back, low gain and modest amp reverb. Without a chorus the signature shimmer is gone, so lean on touch dynamics and percussive muting for the Brazilian comping feel.
Loses the signature shimmer and stereo width of the clean figures
Workaround: Use light vibrato and let neck-pickup warmth plus reverb carry the width
Percussive chord cutting is less even in level
Workaround: Pick lightly and consistently; guitar volume at 8 evens dynamics
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Neck (or neck+middle on a Strat) for a round, warm clean
Yamaha SG or Fender Stratocaster → Compressor → Chorus → Roland JC-120 (clean channel) → JC-120 2x12 speakers → Studio plate/room reverb
Amp effects: reverb (JC-120 has spring reverb; set low if the amp assumption holds, otherwise ambience was studio-added), chorus (JC-120 has built-in stereo chorus/vibrato, the simplest route to his signature shimmer)
Notes are not fast, but the Latin syncopation, chord voicings and fully clean tone demand accurate right-hand control and muting.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings