Masayoshi Takanaka · settings for Epiphone Les Paul Standard + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Tremolo Speed · Tremolo Intensity
Roughly 15-20% wet.
Clean Twin Reverb platform with the Les Paul neck pickup rolled slightly back for a round, glassy 1978 fusion comp tone. Amp spring reverb supplies the plate ambience; chorus and compression are the gaps, handled by touch control until a chorus pedal arrives.
Loses the signature shimmer and stereo width of the clean cutting figures.
Workaround: Use the Vibrato channel's natural liveliness and light reverb; vary pick attack and add subtle finger vibrato on held melody notes for movement.
Chord cutting is less even; accents jump out more than on the record.
Workaround: Play with a very consistent light right hand and keep amp volume moderate so the tubes add a touch of natural compression.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Neck (or neck+middle on a Strat) for a round, warm clean
Yamaha SG or Fender Stratocaster → Compressor → Chorus → Roland JC-120 (clean channel) → JC-120 2x12 speakers → Studio plate/room reverb
Amp effects: reverb (JC-120 has spring reverb; set low if the amp assumption holds, otherwise ambience was studio-added), chorus (JC-120 has built-in stereo chorus/vibrato, the simplest route to his signature shimmer)
Notes are not fast, but the Latin syncopation, chord voicings and fully clean tone demand accurate right-hand control and muting.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings