Pink Floyd · settings for Squier Stratocaster + Line 6 POD Go (direct)
Light squeeze to feed the fuzz.
Volume to unity or slightly hot.
+3dB at 800Hz, -4dB above 4kHz, slight 120Hz cut.
Feedback low, Mix 20%.
440ms, 3-4 repeats, Mix 25%, slight high cut.
Plate, Decay medium, Mix 15%.
POD Go direct: Whowatt 100 (Hiwatt) with Triangle Fuzz in front for the Big Muff's thick midrange sustain, plus compressor, light flanger, ~440ms delay and a touch of plate reverb for the outro solo's violin-like lead.
Triangle Fuzz is a brighter, looser earlier Muff circuit with less midrange thickness.
Workaround: Run Tone low, Sustain high and follow with an EQ block boosting 800Hz and cutting above 4kHz.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge (FS-1) for the outro solo; bridge+neck combined on the first solo
1969 Fender Stratocaster "Black Strat" (FS-1 bridge) → MXR Dyna Comp → Electro-Harmonix Big Muff Pi (Ram's Head) → Electro-Harmonix Electric Mistress → Studio delay → Hiwatt DR103 head -> WEM Super Starfinder 4x12 (Fane Crescendo) → Alembic F-2B preamp -> Yamaha RA-200 rotating speaker cabinet
Amp effects: other (Yamaha RA-200 rotating speaker cabinet run in parallel with the Hiwatt adds subtle rotary modulation)
Notes are not technically dense, but the tone depends on precise bend pitch, wide controlled vibrato and sustained dynamics that are hard to match.