Pink Floyd · settings for Squier Stratocaster + Marshall CODE 25
Level to match clean, tone/EQ dark.
Moderate amount, output just above unity.
Slow rate, shallow depth, low feedback, mix low.
~400 ms, feedback for 3-4 repeats, mix ~25%.
Plexi model on the CODE 25 with the built-in distortion block standing in for a Ram's Head Big Muff: thick mids, rolled-off treble, compressor in front, slow flanger and a ~400ms delay for the soaring outro lead.
Loses the wide stereo rotary shimmer blended under the Hiwatt.
Workaround: Lean on the flanger block at slow rate, or swap it for the chorus block at low depth.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge (FS-1) for the outro solo; bridge+neck combined on the first solo
1969 Fender Stratocaster "Black Strat" (FS-1 bridge) → MXR Dyna Comp → Electro-Harmonix Big Muff Pi (Ram's Head) → Electro-Harmonix Electric Mistress → Studio delay → Hiwatt DR103 head -> WEM Super Starfinder 4x12 (Fane Crescendo) → Alembic F-2B preamp -> Yamaha RA-200 rotating speaker cabinet
Amp effects: other (Yamaha RA-200 rotating speaker cabinet run in parallel with the Hiwatt adds subtle rotary modulation)
Notes are not technically dense, but the tone depends on precise bend pitch, wide controlled vibrato and sustained dynamics that are hard to match.
Every song already dialed in for the Marshall CODE 25.
Marshall CODE 25 settings