Pink Floyd · settings for Squier Stratocaster + Marshall MG30GFX
3 repeats, FX Level 4.
No fuzz pedal, so the MG30GFX's OD2 channel does the heavy lifting: mid-forward, treble tamed, amp delay for bloom. Ceramic Strat singles need extra gain and a rolled-off tone knob to approach the Big Muff's thick, singing sustain.
Amp OD2 is tighter and more compressed than the Muff's thick, violin-like sustain.
Workaround: Max mids, gain near 8, guitar volume full, play near the amp for feedback sustain.
Loses the subtle rotary/flange swirl on the sustained notes.
Workaround: Amp flanger can substitute if you forgo the delay, since one FX runs at a time.
Slightly less even attack and front-end sustain into the gain stage.
Workaround: OD2's own compression plus steady picking covers most of it.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge (FS-1) for the outro solo; bridge+neck combined on the first solo
1969 Fender Stratocaster "Black Strat" (FS-1 bridge) → MXR Dyna Comp → Electro-Harmonix Big Muff Pi (Ram's Head) → Electro-Harmonix Electric Mistress → Studio delay → Hiwatt DR103 head -> WEM Super Starfinder 4x12 (Fane Crescendo) → Alembic F-2B preamp -> Yamaha RA-200 rotating speaker cabinet
Amp effects: other (Yamaha RA-200 rotating speaker cabinet run in parallel with the Hiwatt adds subtle rotary modulation)
Notes are not technically dense, but the tone depends on precise bend pitch, wide controlled vibrato and sustained dynamics that are hard to match.
Every song already dialed in for the Marshall MG30GFX.
Marshall MG30GFX settings