Pink Floyd · settings for Squier Stratocaster + Marshall DSL40CR
At zero: Gain · Volume
3.
No fuzz pedal, so the Marshall's OD1 mode supplies the sustain. Bridge pickup, mids pushed, highs tamed, a touch of amp reverb for the studio space. Thick and singing, but less wooly than a Big Muff.
OD1 gives sustain but with Marshall grain, less wooly saturated bloom
Workaround: Max mids, gain 7.5, roll guitar tone back and play with heavy sustain near the amp
Notes lose the bloom and repeats that fill the slow phrasing
Workaround: Use amp reverb at 3 and let notes ring full length; avoid clipping phrases short
Loses the subtle rotary/flange swirl on the sustained notes
Workaround: Wide slow vibrato in the fretting hand imitates the shimmer
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge (FS-1) for the outro solo; bridge+neck combined on the first solo
1969 Fender Stratocaster "Black Strat" (FS-1 bridge) → MXR Dyna Comp → Electro-Harmonix Big Muff Pi (Ram's Head) → Electro-Harmonix Electric Mistress → Studio delay → Hiwatt DR103 head -> WEM Super Starfinder 4x12 (Fane Crescendo) → Alembic F-2B preamp -> Yamaha RA-200 rotating speaker cabinet
Amp effects: other (Yamaha RA-200 rotating speaker cabinet run in parallel with the Hiwatt adds subtle rotary modulation)
Notes are not technically dense, but the tone depends on precise bend pitch, wide controlled vibrato and sustained dynamics that are hard to match.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings