Slipknot · settings for Epiphone Les Paul Standard + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Reverb · Tremolo Speed · Tremolo Intensity
No effects needed for this part.
A Twin Reverb with no drive pedals can't reach VHT Pitbull high gain. Set a loud, aggressive clean platform on the Normal channel with bright mids and heavy attack, then buy a high-gain distortion pedal; everything else is damage control.
Without a drive pedal the riff is clean; the entire character of the part is missing.
Workaround: Push amp volume to 5-6 for edge-of-breakup and dig in hard with heavy palm mutes; accept a dirty-clean riff.
Staccato stops ring and hiss instead of dropping dead silent.
Workaround: Mute with the palm and fretting-hand fingers immediately after each chug; roll guitar volume off during long rests.
Minor clean-part shimmer absent; barely audible on this riff anyway.
Workaround: Leave out; the main riff is dry and unmodulated.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Guitar (active bridge humbucker) → Noise gate → Bixonic Expandora (boost/tighten, possible) → VHT Pitbull Ultra Lead head → Carvin 4x12 cabinet
The notes are simple, but the groove demands precise muting and rhythmic placement; sloppiness is instantly exposed by the high gain.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings