Slipknot · settings for Epiphone Les Paul Standard + Line 6 Helix Floor (direct)
Fast cut for the stop-start gaps.
Tightening boost, not gain.
Mic 57 Dynamic, distance 2", high cut 9.0kHz, low cut 85Hz.
-3dB at 400Hz, +2dB at 2.5kHz, low cut 80Hz.
Studio room only, keep nearly dry.
Helix direct: PV Panama (5150) into a 4x12 IR for the VHT-style tight high gain, Scream 808 in front to tighten the drop-B chugs, hard noise gate for the staccato stops. ProBucker bridge, everything wide open.
Loses a little of the midrange push and front-end tightening on the chugs.
Workaround: Scream 808 block with drive low and level high does the same tightening job.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Guitar (active bridge humbucker) → Noise gate → Bixonic Expandora (boost/tighten, possible) → VHT Pitbull Ultra Lead head → Carvin 4x12 cabinet
The notes are simple, but the groove demands precise muting and rhythmic placement; sloppiness is instantly exposed by the high gain.
Every song already dialed in for the Line 6 Helix Floor.
Line 6 Helix Floor presets