Slipknot · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Ultra Gain OD2 on the DSL40CR with the bridge ProBucker gets close to the VHT's tight drop-B wall. Treble and presence up, mids moderate, resonance high for chug weight. No gate means you must mute by hand.
High-gain stops ring and hiss instead of slamming shut.
Workaround: Mute with the picking-hand palm and fretting-hand fingers on every rest; roll guitar volume off between sections.
Slightly less front-end tightening and midrange push into the amp.
Workaround: Raise the amp's middle a notch and pick harder near the bridge to recover the push.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Guitar (active bridge humbucker) → Noise gate → Bixonic Expandora (boost/tighten, possible) → VHT Pitbull Ultra Lead head → Carvin 4x12 cabinet
The notes are simple, but the groove demands precise muting and rhythmic placement; sloppiness is instantly exposed by the high gain.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings