Slipknot · settings for Epiphone Les Paul Standard + Line 6 POD Go (direct)
Threshold high enough to kill hum between chugs, decay fast.
Tightens lows, pushes mids.
Mic 57 dynamic, distance low, high cut 9kHz, low cut 85Hz.
-3dB at 400Hz, +2dB at 3kHz, high cut 10kHz.
Mix 8% only if the dry sound feels too sterile.
Direct POD Go build: PV Panama (5150) model with a 4x12 IR for tight drop-B chug, Scream 808 in front to firm up the low end, and a hard noise gate for the staccato stops. ProBucker bridge, volume and tone wide open.
Slightly less unique midrange push and front-end tightening than the original boost.
Workaround: Scream 808 with drive low and level high does the same tightening job on the POD Go.
No phase shimmer on clean/atmospheric moments; barely audible on this riff anyway.
Workaround: Use the POD Go Phase 90 block if you want that texture on clean passages.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Guitar (active bridge humbucker) → Noise gate → Bixonic Expandora (boost/tighten, possible) → VHT Pitbull Ultra Lead head → Carvin 4x12 cabinet
The notes are simple, but the groove demands precise muting and rhythmic placement; sloppiness is instantly exposed by the high gain.