Ozzy Osbourne · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Classic Gain channel in Crunch, gain near maximum, for a cranked-plexi buzzsaw. Mids pushed hard, bass tight, bridge ProBucker wide open. Tone shift off. No pedals owned, so amp gain replaces the Distortion+ and the midrange hump is dialed in on the panel.
Loses the mid-forward, compressed front-end push that gives the riff its singing saturation.
Workaround: Run Classic Crunch gain at 9-10 with master up; tube compression approximates the squash.
Without the 250-1k hump the riff sounds flatter and less vocal.
Workaround: Middle at 8, bass low, tone shift button left OFF to keep mids intact.
Rhythm track loses the stereo width and slight detune of the mix.
Workaround: Double-track the riff when recording; live, play it dry as the album riff is essentially dry.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
1974 Gibson Les Paul Custom (bridge pickup) → MXR Distortion+ → MXR Ten Band Graphic EQ → Marshall JMP 1959 Super Lead MKII (Input I, high treble channel) → Marshall 1960A/1960B 4x12 with Altec 417-8H → AMS DMX 15-80S Digital Delay (mix-stage chorus/width)
The riff itself is straightforward power chords and single-note lines, but the tone depends on clean muting and very even picking to survive the mid-heavy, compressed distortion.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings