Ozzy Osbourne · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
JCM800 into the High input gets most of Rhoads' buzzsaw mid-crunch without a Distortion+. Push the preamp, scoop nothing, lift the mids, bridge ProBucker wide open, and keep the low end tight.
Less compression and midrange push into the front end; slightly looser attack.
Workaround: Run the High input with preamp at 8 and middle at 7 to mimic the mid-forward saturation.
Loses the big 500Hz vocal hump and 16k air of the recorded riff.
Workaround: Middle at 7 with bass pulled to 3 approximates the hump; add presence for top-end air.
Rhythm track sits narrow and dry instead of stereo-wide.
Workaround: Double-track the riff if recording; live, the dry amp is authentic to Rhoads' stage sound.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
1974 Gibson Les Paul Custom (bridge pickup) → MXR Distortion+ → MXR Ten Band Graphic EQ → Marshall JMP 1959 Super Lead MKII (Input I, high treble channel) → Marshall 1960A/1960B 4x12 with Altec 417-8H → AMS DMX 15-80S Digital Delay (mix-stage chorus/width)
The riff itself is straightforward power chords and single-note lines, but the tone depends on clean muting and very even picking to survive the mid-heavy, compressed distortion.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings