Ozzy Osbourne · settings for Epiphone Les Paul Standard + Vox AC30C2
At zero: Volume · Reverb · Tremolo Speed · Tremolo Depth
No effects needed for this part.
Randy's cranked Super Lead with a Distortion+ out front, rebuilt on an AC30 Top Boost: bridge ProBucker, Top Boost volume past noon for native crunch, mids faked by rolling off treble and bass. Chimier and less saturated, but mid-forward and tight.
Without a boost the AC30 gives crunch, not the saturated, compressed buzzsaw sustain of the riff.
Workaround: Push volume_tb to 7.5-9 with master low; dig in hard with the pick to force the power section into saturation.
Loses the big 250-500Hz hump that gives the riff its vocal, cutting midrange.
Workaround: Lower bass to 3 and treble to about 5.5 so the AC30's fixed mids dominate; use tone_cut to trim fizz.
Rhythm track stays mono and narrow rather than wide across the stereo field.
Workaround: Double-track the riff on two takes if recording; live, accept the mono sound.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
1974 Gibson Les Paul Custom (bridge pickup) → MXR Distortion+ → MXR Ten Band Graphic EQ → Marshall JMP 1959 Super Lead MKII (Input I, high treble channel) → Marshall 1960A/1960B 4x12 with Altec 417-8H → AMS DMX 15-80S Digital Delay (mix-stage chorus/width)
The riff itself is straightforward power chords and single-note lines, but the tone depends on clean muting and very even picking to survive the mid-heavy, compressed distortion.