Ozzy Osbourne · settings for Epiphone Les Paul Standard + Vox AC15C1
At zero: Volume · Reverb · Tremolo Speed · Tremolo Depth
No effects needed for this part.
Randy's mid-forward buzzsaw riff on an AC15 Top Boost pushed hard. With no drive pedal, the amp's own tube breakup plus both guitar volumes wide open gets a tight, cutting crunch, though less saturated and Marshall-ish than the original.
Without it the riff lacks the compressed, saturated buzzsaw sustain; AC15 breakup is looser and grittier.
Workaround: Run Top Boost volume at 9-10 with master low, bridge pickup and guitar volume maxed, and pick hard for the most compression the amp can give.
The big 250-500Hz hump that gives the riff its vocal, cutting midrange is absent on the scooped-ish AC15 voicing.
Workaround: Raise bass to 6 and keep treble moderate with tone cut around 3 to fake a low-mid bump.
No stereo width or slight detune spreading the rhythm tracks.
Workaround: Play dry and mono; double-track if recording.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
1974 Gibson Les Paul Custom (bridge pickup) → MXR Distortion+ → MXR Ten Band Graphic EQ → Marshall JMP 1959 Super Lead MKII (Input I, high treble channel) → Marshall 1960A/1960B 4x12 with Altec 417-8H → AMS DMX 15-80S Digital Delay (mix-stage chorus/width)
The riff itself is straightforward power chords and single-note lines, but the tone depends on clean muting and very even picking to survive the mid-heavy, compressed distortion.