Crowbar · settings for Epiphone Les Paul Standard + Blackstar ID:Core 20 V3
No effects needed for this part.
OD2 voice on the ID:Core with heavy bass, bright treble and a mid-American ISF gets close to the boosted Randall sludge tone. Bridge ProBucker, everything wide open, no onboard ambience. The 20W cab is the main limit on low-end weight.
Less tightened low end and reduced pick attack on palm mutes.
Workaround: Raise amp gain slightly and treble, keep guitar volume at 10 and pick hard near the bridge.
Hiss and feedback bleed between the long sustained chords.
Workaround: Mute with the palm and fretting hand at the end of each chord; back off gain if needed.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (EMG 81)
ESP/LTD Viper-type guitar with EMG 81 bridge → Noise gate → Boss MT-2 Metal Zone (clean boost, drive at 0) → Randall RG100ES head → Marshall 1960B 4x12 with Vintage 30s
Harmonically and technically simple, but the groove demands exact palm-mute control and heavy-gauge strings at B standard to sound right.
Every song already dialed in for the Blackstar ID:Core 20 V3.
Blackstar ID:Core 20 V3 settings