Crowbar · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
JCM800 High input, preamp cranked for sludge saturation, scooped-ish mids with big bass and firm treble. ProBuckers are lower output than an EMG 81, so gain goes higher. Bridge pickup, everything wide open, slow palm-muted chord weight.
Without a front-end boost the low end is looser and palm mutes lose the sharp attack.
Workaround: Push preamp to 8.5-9 and keep middle near 4; tighten by picking closer to the bridge and strict palm muting.
Cranked preamp hiss bleeds into the long gaps between sustained chords.
Workaround: Mute strings with the fretting hand and palm heel during rests; roll guitar volume down between chord stabs.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (EMG 81)
ESP/LTD Viper-type guitar with EMG 81 bridge → Noise gate → Boss MT-2 Metal Zone (clean boost, drive at 0) → Randall RG100ES head → Marshall 1960B 4x12 with Vintage 30s
Harmonically and technically simple, but the groove demands exact palm-mute control and heavy-gauge strings at B standard to sound right.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings