Crowbar · settings for Epiphone Les Paul Standard + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Reverb · Tremolo Speed · Tremolo Intensity
No effects needed for this part.
Crowbar's boosted solid-state wall of gain can't be reached with a clean Twin Reverb and no pedals. Set the Twin as dark, mid-heavy and loud as possible on the bridge ProBucker, push it into light tube breakup, and accept a thick clean-ish riff until a distortion pedal is added.
Without it there is no high-gain distortion at all; the part sounds like a loud clean power chord.
Workaround: Crank amp volume to 7-8 for edge-of-breakup and dig in hard with heavy palm mutes; use full humbucker (no coil split) for maximum output.
No mid-focused tightening of the low end; chords get flabby at B standard.
Workaround: Lower amp bass slightly if the riff gets muddy and pick closer to the bridge.
Hiss and string noise between the long sustained chords.
Workaround: Mute with the picking-hand palm and left-hand fingers at the end of each chord.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (EMG 81)
ESP/LTD Viper-type guitar with EMG 81 bridge → Noise gate → Boss MT-2 Metal Zone (clean boost, drive at 0) → Randall RG100ES head → Marshall 1960B 4x12 with Vintage 30s
Harmonically and technically simple, but the groove demands exact palm-mute control and heavy-gauge strings at B standard to sound right.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings