Crowbar · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Ultra Gain OD1 on the DSL40CR gets close to the boosted solid-state sludge roar: thick bass, slightly scooped mids, bright presence for palm-mute attack. Bridge ProBucker full up. No boost pedal means slightly less tight low end.
Low end stays looser and palm mutes lack the tightened solid-state attack.
Workaround: Raise Ultra gain slightly, keep bass at 7.5 and presence 6, and pick harder near the bridge for attack.
Hiss and hum ring out between the long sustained chords.
Workaround: Mute with the palm and left hand during gaps; roll the bridge volume off between phrases.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (EMG 81)
ESP/LTD Viper-type guitar with EMG 81 bridge → Noise gate → Boss MT-2 Metal Zone (clean boost, drive at 0) → Randall RG100ES head → Marshall 1960B 4x12 with Vintage 30s
Harmonically and technically simple, but the groove demands exact palm-mute control and heavy-gauge strings at B standard to sound right.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings