Pantera · settings for Epiphone Les Paul Standard + Fender Mustang LT25
Rate slow, mix ~25% — barely audible.
Light: sustain/level low, around 20-25%.
Dimebag's brittle Randall rhythm tone on a Mustang LT25: Metal 2000 model, bridge ProBucker, scooped lower mids with spiky treble, subtle flanger doubling, no reverb. The 8-inch speaker limits low end, so keep bass moderate and lean on upper-mid bite.
Loses the 400 Hz cut plus 1.6-3.2 kHz spike that makes the riff cut.
Workaround: Approximate with amp Middle at 3 and Treble at 7.5; roll tone to 10.
No clean front-end level boost or 500-800 Hz notch into the preamp.
Workaround: Raise amp gain slightly and keep Middle low to mimic the notch.
High-gain hiss and hum ring out between riff stabs.
Workaround: Mute with the picking hand and palm edge; back off bridge volume between phrases.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (L-500XL); neck pickup for the clean intro/verse figures
Dean ML 'Dean From Hell' (Bill Lawrence L-500XL bridge) → Furman PQ-3 Parametric EQ → MXR M-109 Six Band Graphic EQ → Rocktron/Boss noise gate → MXR M-126 Flanger/Doubler → Randall RG100ES head → Randall 4x12 cabinet
Amp effects: chorus (Only on the clean sections tracked through the Roland JC-120's stereo chorus; not on the heavy riff)
The riff itself is rhythmically straightforward, but nailing the tight muting, the harmonic squeals and the clean/heavy contrast takes control.
Every song already dialed in for the Fender Mustang LT25.
Fender Mustang LT25 settings