Pantera · settings for Epiphone Les Paul Standard + Marshall MG30GFX
Slowest/shallowest the amp allows.
Heavy riff tone: bridge ProBucker into the MG30's OD2 channel, scooped lower mids with spiky treble, reverb off. Built-in flanger at a low FX level stands in for Dime's always-on doubler. No EQ pedals means less of the brittle front-end push.
Loses the 400 Hz scoop plus 1.6-3.2 kHz spike that defines the brittle cutting rhythm tone.
Workaround: Approximate with amp Middle at 3 and Treble 7.5; roll gain back slightly for clarity.
No front-end 3-4 dB push, so the riff attack is softer and less aggressive.
Workaround: Raise channel Volume and pick harder near the bridge for transient bite.
High-gain hiss rings between riff stabs instead of cutting off cleanly.
Workaround: Mute with the fretting hand and right-hand palm between stabs.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (L-500XL); neck pickup for the clean intro/verse figures
Dean ML 'Dean From Hell' (Bill Lawrence L-500XL bridge) → Furman PQ-3 Parametric EQ → MXR M-109 Six Band Graphic EQ → Rocktron/Boss noise gate → MXR M-126 Flanger/Doubler → Randall RG100ES head → Randall 4x12 cabinet
Amp effects: chorus (Only on the clean sections tracked through the Roland JC-120's stereo chorus; not on the heavy riff)
The riff itself is rhythmically straightforward, but nailing the tight muting, the harmonic squeals and the clean/heavy contrast takes control.
Every song already dialed in for the Marshall MG30GFX.
Marshall MG30GFX settings