Pantera · settings for Epiphone Les Paul Standard + Boss Katana (50/100 MkII, Gen 3)
At zero: Fx · Delay
Treble Booster type, level moderate, mild drive.
Chorus/Flanger green, depth low, rate slow, subtle mix.
Plate, short decay, low level.
Dimebag's Cemetery Gates solo on a Katana: Brown voicing with scooped mids, bridge ProBucker, built-in booster as the EQ front-end push, subtle mod for the doubler and light reverb for studio ambience.
Less surgical mid-scoop and front-end bite than Dime's stacked EQs.
Workaround: Use amp Middle near 2-3 and Treble 8 plus the Booster block; Boss Tone Studio adds a Graphic EQ block.
Hiss and feedback between high-gain phrases.
Workaround: Palm-mute and roll the guitar volume between phrases; Boss Tone Studio has a Noise Suppressor block.
Loses the parked mid-hump on a few lead accents.
Workaround: Nudge the amp Middle up slightly for those phrases or skip it; usage was minimal.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker (L-500XL)
Dean ML (Bill Lawrence L-500XL, bridge) → Dunlop Cry Baby wah → Furman PQ-3 Parametric EQ → MXR Six Band Graphic EQ → MXR M-126 Flanger/Doubler → Noise gate → Randall RG100ES head → Randall 412JB 4x12
The solo opens melodically then escalates into rapid picked runs, diminished/whole-tone passing ideas, tapped harmonics and bar-manipulated squeals; the phrasing and vibrato are as hard as the notes.
Every song already dialed in for the Boss Katana (50/100 MkII, Gen 3).
Boss Katana (50/100 MkII, Gen 3) settings