Pantera · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume
2 of 10.
Dimebag's scooped, razor-bright Randall lead on a DSL40CR: Ultra Gain OD1, mids scooped with the tone shift button, treble and presence high, bridge humbucker wide open. Tube Marshall is warmer than the solid-state original, so keep gain moderate and lows tight.
Without a boosting EQ the lead is less scooped, less tight and less cutting.
Workaround: Engage the DSL tone shift button and keep middle near 3, treble 8, presence 7 for a similar curve.
Lead sounds narrower and less like two stacked guitars.
Workaround: Play with heavier vibrato and sustain; let amp reverb add a touch of width.
High-gain hiss and squeal between phrases.
Workaround: Mute with the picking-hand palm and left-hand damping between lines.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker (L-500XL)
Dean ML (Bill Lawrence L-500XL, bridge) → Dunlop Cry Baby wah → Furman PQ-3 Parametric EQ → MXR Six Band Graphic EQ → MXR M-126 Flanger/Doubler → Noise gate → Randall RG100ES head → Randall 412JB 4x12
The solo opens melodically then escalates into rapid picked runs, diminished/whole-tone passing ideas, tapped harmonics and bar-manipulated squeals; the phrasing and vibrato are as hard as the notes.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings