Pantera · settings for Epiphone Les Paul Standard + Yamaha THR10II
Slow rate, shallow depth via Effect at 3.
Small room, short, low mix (Echo/Reverb 2).
Dimebag's scooped, razor-edged RG100ES lead on a THR10II: Hi Gain mode, bridge ProBucker, mids pulled way down, treble and gain up, plus a touch of flanger-as-doubler for width. Small desktop amp, so expect tightness over 4x12 girth.
Less mid-scoop depth and less front-end boost into the amp
Workaround: Drop Middle to 2-3 and raise Gain/Treble; use the THR Remote app EQ if available
High-gain hiss and squeal feedback between phrases
Workaround: Mute with the picking hand palm and roll back bridge volume during rests
No vocal mid-hump on isolated lead accents
Workaround: Only used occasionally; emphasize with vibrato and pick attack instead
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker (L-500XL)
Dean ML (Bill Lawrence L-500XL, bridge) → Dunlop Cry Baby wah → Furman PQ-3 Parametric EQ → MXR Six Band Graphic EQ → MXR M-126 Flanger/Doubler → Noise gate → Randall RG100ES head → Randall 412JB 4x12
The solo opens melodically then escalates into rapid picked runs, diminished/whole-tone passing ideas, tapped harmonics and bar-manipulated squeals; the phrasing and vibrato are as hard as the notes.