Pantera · settings for Epiphone Les Paul Standard + Fender Frontman 10G
No effects needed for this part.
Dime's scooped Randall lead on a 10W Frontman: overdrive on, bridge humbucker, treble high, bass moderate to fake the mid scoop. Expect a thinner, buzzier saturation and no doubler width, but the aggressive bite is reachable.
Without a mid cut and boost the tone stays boxy and lacks Dime's scooped, saturated front end.
Workaround: Approximate by maxing treble, pulling bass to 4, and rolling guitar tone slightly; pick nearer the bridge for bite.
Lead loses the wide, two-guitar thickness heard under the solo.
Workaround: Play with heavier vibrato and sustain; no single-amp substitute exists.
High-gain hiss and squeal between phrases is uncontrolled.
Workaround: Mute with the fretting-hand palm and right-hand damping between phrases.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker (L-500XL)
Dean ML (Bill Lawrence L-500XL, bridge) → Dunlop Cry Baby wah → Furman PQ-3 Parametric EQ → MXR Six Band Graphic EQ → MXR M-126 Flanger/Doubler → Noise gate → Randall RG100ES head → Randall 412JB 4x12
The solo opens melodically then escalates into rapid picked runs, diminished/whole-tone passing ideas, tapped harmonics and bar-manipulated squeals; the phrasing and vibrato are as hard as the notes.
Every song already dialed in for the Fender Frontman 10G.
Fender Frontman 10G settings