Pantera · settings for Epiphone Les Paul Standard + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Tremolo Speed · Tremolo Intensity
A pedal-free Twin Reverb can't reach Dime's scooped Randall saturation. Bridge ProBucker into a loud, bright, mid-scooped Twin pushed near breakup gets the EQ shape and attack; the actual high gain needs an overdrive/distortion pedal you don't yet own.
Without a boost and scoop pedal there is no saturation or Dime's mid-scooped bite.
Workaround: Set amp mids low, treble high and volume near breakup; dig in hard for grit.
Lead sounds narrower and thinner than the wide doubled record tone.
Workaround: Play with wide vibrato and sustain; let amp reverb add a little width.
Less relevant with a clean amp, but any future boost will hiss.
Workaround: Mute with the picking hand and roll the guitar volume down during rests.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker (L-500XL)
Dean ML (Bill Lawrence L-500XL, bridge) → Dunlop Cry Baby wah → Furman PQ-3 Parametric EQ → MXR Six Band Graphic EQ → MXR M-126 Flanger/Doubler → Noise gate → Randall RG100ES head → Randall 412JB 4x12
The solo opens melodically then escalates into rapid picked runs, diminished/whole-tone passing ideas, tapped harmonics and bar-manipulated squeals; the phrasing and vibrato are as hard as the notes.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings