Ozzy Osbourne · settings for Epiphone Les Paul Standard + Blackstar ID:Core 20 V3
Feedback low, level 15-20%.
Room, level very low (~10%).
Randy's mid-forward Super Lead plus Distortion+ translated to the ID:Core 20: OD1 voice, ISF toward British for the 500Hz hump, bridge ProBucker full up. Tight medium-high gain, bright top, a touch of delay for width.
Amp gain alone is slightly looser and less midrange-spiky than the germanium-ish MXR grit
Workaround: Run OD1 with gain 6.5 and ISF high; pick hard for attack
No dedicated 500Hz boost or level kick, so the lead sits less above a band
Workaround: ISF at 8 and bass pulled back replicates much of the midrange hump
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
1974 Gibson Les Paul Custom (bridge pickup) → MXR Distortion + → MXR Ten Band Graphic EQ → Marshall JMP 1959 Super Lead 100W (Input I, high-treble) → Marshall 4x12 cabs with Altec 417-8H speakers → AMS DMX 15-80S Digital Delay (console, short delay/detune)
The solo demands clean fast picking, accurate position jumps and controlled vibrato at tempo; the composed, classically flavored lines leave little room to fake phrasing.
Every song already dialed in for the Blackstar ID:Core 20 V3.
Blackstar ID:Core 20 V3 settings