Ozzy Osbourne · settings for Epiphone Les Paul Standard + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Reverb · Tremolo Speed · Tremolo Intensity
No effects needed for this part.
A Twin Reverb with ProBuckers can't reach Rhoads' Distortion+ into a cranked Super Lead without a drive pedal. Dial the loudest mid-forward edge-of-breakup clean on the Normal channel, bridge pickup wide open, and accept a much tamer gain level until a distortion pedal is added.
Without it the Twin stays clean; no sustain, no saturation, no lead singing quality.
Workaround: Crank amp volume to 7-8 for mild tube grit and dig in hard with the pick; expect only edge-of-breakup.
Loss of the 500Hz hump and level boost that makes the lead cut through.
Workaround: Set amp middle at 8 and bass low to approximate the midrange hump.
No short-delay widening/detune, so the tone sounds narrower than the record.
Workaround: Skip it; this was a console effect mostly on rhythm tracks, not essential live.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
1974 Gibson Les Paul Custom (bridge pickup) → MXR Distortion + → MXR Ten Band Graphic EQ → Marshall JMP 1959 Super Lead 100W (Input I, high-treble) → Marshall 4x12 cabs with Altec 417-8H speakers → AMS DMX 15-80S Digital Delay (console, short delay/detune)
The solo demands clean fast picking, accurate position jumps and controlled vibrato at tempo; the composed, classically flavored lines leave little room to fake phrasing.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings