Ozzy Osbourne · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume
Randy's Crazy Train lead on a DSL40CR: Classic Gain in Crunch is too polite alone, so use Ultra Gain OD1 with mids pushed hard to mimic the Distortion+ into a lightly overdriven Super Lead. Bridge ProBucker, everything wide open.
Loses the hard, slightly compressed germanium-ish edge and sustain in front of the amp.
Workaround: Use Ultra Gain OD1 with gain near 5.5 and middle high; pick harder for attack.
Less level boost and 500Hz hump, so the lead cuts less over a band.
Workaround: Middle at 8 plus Tone Shift button OFF gets much of the hump; raise Ultra volume for level.
Lead sounds narrower than the wide, detuned, multi-tracked record.
Workaround: Record a second take panned opposite instead of chasing the width live.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
1974 Gibson Les Paul Custom (bridge pickup) → MXR Distortion + → MXR Ten Band Graphic EQ → Marshall JMP 1959 Super Lead 100W (Input I, high-treble) → Marshall 4x12 cabs with Altec 417-8H speakers → AMS DMX 15-80S Digital Delay (console, short delay/detune)
The solo demands clean fast picking, accurate position jumps and controlled vibrato at tempo; the composed, classically flavored lines leave little room to fake phrasing.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings