Ozzy Osbourne · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
JCM800 High input with preamp pushed to cover the missing MXR Distortion+ boost, mids up and bass tight for Rhoads' cutting, midrange-forward solo tone. Bridge ProBucker full up, tone wide open.
Loses the sharp, compressed sustain and extra front-end push that defines the lead
Workaround: Run the High input with preamp at 8 and guitar volume maxed; pick harder for attack
Less 500Hz-centered cut and level boost, so the lead sits lower in the mix
Workaround: Middle at 8 and presence at 6 approximates the midrange hump
Lead sounds narrower than the detuned, doubled studio tracks
Workaround: Nothing on the amp covers it; play dry and lean on vibrato for width
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
1974 Gibson Les Paul Custom (bridge pickup) → MXR Distortion + → MXR Ten Band Graphic EQ → Marshall JMP 1959 Super Lead 100W (Input I, high-treble) → Marshall 4x12 cabs with Altec 417-8H speakers → AMS DMX 15-80S Digital Delay (console, short delay/detune)
The solo demands clean fast picking, accurate position jumps and controlled vibrato at tempo; the composed, classically flavored lines leave little room to fake phrasing.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings