Van Halen · settings for Epiphone Les Paul Standard + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Tremolo Speed · Tremolo Intensity
A Twin Reverb cannot produce Eddie's cranked-plexi saturation without a drive pedal. Set the Vibrato channel mid-forward and loud with a touch of reverb for the plate ambience, use the bridge ProBucker wide open, and treat this as the cleanest possible approximation until an overdrive is added.
Without high gain the legato and tapped triplets will not sustain or speak at all.
Workaround: Push amp volume to 6-7, dig in hard, and play near the amp for feedback-assisted sustain; expect a clean-to-edge-of-breakup tone only.
Loses the signature slow swirl and upper-mid emphasis in the tapping section.
Workaround: No amp phaser; the amp tremolo is a different effect, so leave it off and accept a dry tone.
Less thickening and no tape-echo coloration behind the runs.
Workaround: Amp reverb at a low setting gives a small amount of tail in its place.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (the guitar's only pickup)
Frankenstrat (bridge PAF) → MXR M117 Flanger → MXR Phase 90 → Maestro Echoplex EP-3 → Univox EC-80A tape echo (final note) → Marshall 1959 Super Lead 100W on Variac → Marshall 4x12 cabinet → Studio plate reverb (mix)
A benchmark virtuoso piece: sustained tapping triplets, aggressive bar work and rubato phrasing demand advanced technique, and the tone itself needs heavy power-tube compression to make the legato speak.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings