Van Halen · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
A JCM800 through the High input gets close to the brown sound: mid-forward, saturated, tight. ProBucker bridge needs a touch more preamp than a PAF. No modulation or delay available, so the tone is the dry core of Eruption.
Loses the signature slow swirl and upper-mid emphasis in the tapping section.
Workaround: Push middle and presence a bit higher to mimic the phaser's mid hump; accept a dry tone.
No short slapback thickening or Echoplex preamp push into the front end.
Workaround: Use the FX loop empty and lean on amp saturation; play slightly harder for body.
Dry sound; the track's room bloom is absent.
Workaround: Play in a live-sounding room or add plate reverb at the mix stage when recording.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (the guitar's only pickup)
Frankenstrat (bridge PAF) → MXR M117 Flanger → MXR Phase 90 → Maestro Echoplex EP-3 → Univox EC-80A tape echo (final note) → Marshall 1959 Super Lead 100W on Variac → Marshall 4x12 cabinet → Studio plate reverb (mix)
A benchmark virtuoso piece: sustained tapping triplets, aggressive bar work and rubato phrasing demand advanced technique, and the tone itself needs heavy power-tube compression to make the legato speak.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings