Rage Against the Machine · settings for Epiphone Les Paul Standard + Boss Katana (50/100 MkII, Gen 3)
At zero: Booster · Fx · Delay
Flanger type, slow rate, wide depth, feedback around 40%, Mod knob 4.
Room/Plate, Reverb 2, short decay.
JCM800 boost-channel crunch from the Katana's Lead mode, neck humbucker rolled slightly for Telecaster-ish thump. Mod section covers the intro flanger; a touch of reverb for the live room. Drop D, palm-muted and dry.
Slightly less volume lift for lead lifts; riff tone unaffected
Workaround: Save a second Katana patch with Volume +1 or use the Booster block set to clean boost
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Neck single-coil for the main riff
1982 Fender Telecaster (neck pickup, drop D) → Marshall JCM800 2205 boost channel input → FX loop: Ibanez DFL Flanger → FX loop: DOD FX40B EQ boost → FX loop: DigiTech Whammy WH-1 (solo only) → Peavey 4x12 with Celestion G12K-85
Amp effects: reverb (The JCM800 2205 has onboard spring reverb; Morello's documented setting is about 7, though live FOH ambience dominates)
The notes are simple; the challenge is groove, muting accuracy and dynamic control between the quiet and full-gain passages.
Every song already dialed in for the Boss Katana (50/100 MkII, Gen 3).
Boss Katana (50/100 MkII, Gen 3) settings