Rage Against the Machine · settings for Epiphone Les Paul Standard + Marshall MG30GFX
Slow rate, wide depth, moderate feedback.
Neck ProBucker into the MG30's OD1 channel for a mid-forward Marshall crunch. Built-in flanger covers the opening sustained chord, a touch of reverb for air. Tune to drop D and keep gain moderate so palm mutes stay percussive.
No clean level lift for lead lifts; riff tone unaffected.
Workaround: Nudge the amp Volume up a notch or use full guitar volume for the loudest riff hits.
No two-octave dive squeals, though those happen in the solo, not this riff.
Workaround: Skip it for the riff section entirely.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Neck single-coil for the main riff
1982 Fender Telecaster (neck pickup, drop D) → Marshall JCM800 2205 boost channel input → FX loop: Ibanez DFL Flanger → FX loop: DOD FX40B EQ boost → FX loop: DigiTech Whammy WH-1 (solo only) → Peavey 4x12 with Celestion G12K-85
Amp effects: reverb (The JCM800 2205 has onboard spring reverb; Morello's documented setting is about 7, though live FOH ambience dominates)
The notes are simple; the challenge is groove, muting accuracy and dynamic control between the quiet and full-gain passages.
Every song already dialed in for the Marshall MG30GFX.
Marshall MG30GFX settings