TOOL · settings for Epiphone Les Paul Standard + Fender Frontman 10G
No effects needed for this part.
Pneuma's thick mid-forward drop-D roar squeezed into a 10W solid-state practice amp: bridge ProBucker, overdrive switch on, treble moderate, bass pulled back so the Frontman's small speaker stays tight instead of farting out.
Loses the rhythmic shimmer that opens space between the riff's syncopated hits.
Workaround: Play the figure with tight palm-mute release so the gaps breathe; no delay available on this amp.
No front-end EQ tightening, so the low end is looser and less focused.
Workaround: Compensate by keeping amp bass low and treble up, picking nearer the bridge.
No stereo swirl or width under the dry tone.
Workaround: Accept a mono dry tone; the swirl was low in the mix anyway.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom Silverburst (bridge humbucker) → MXR Micro Amp + (front-end boost/EQ) → Boss DD-3 Digital Delay → Signal split to Diezel VH4 / Marshall Super Bass / Bogner Uberschall + Rivera Knucklehead → Mesa 4x12 and Marshall 4x12 (V30s or Greenbacks) → Leslie cabinet mic'd in stereo
The notes are not technically extreme, but locking the syncopated drop-D figure to Danny Carey's shifting subdivisions and keeping mute control clean is the real challenge.
Every song already dialed in for the Fender Frontman 10G.
Fender Frontman 10G settings