TOOL · settings for Epiphone Les Paul Standard + Line 6 Helix Floor (direct)
Controls drop-D palm-mute silence.
Always on.
Mic 57 Dynamic at cap edge, 2in, low cut 80Hz, high cut 7.5kHz.
-3dB at 400Hz, +2dB at 1.2kHz.
Quarter note at song tempo (~147 BPM), Feedback 20%, Mix 15%.
Stereo width wide.
Helix direct: Placater Dirty into a 4x12 V30 cab for the Diezel/Marshall blend, Kinky Boost out front for front-end tightening, quarter-note delay low in the mix, slow stereo chorus standing in for the Leslie. Bridge ProBucker, drop D.
Single amp block is narrower and less layered than five tracked guitars.
Workaround: Run a second parallel amp block (Brit Plexi Brt) panned opposite the Placater at lower level.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom Silverburst (bridge humbucker) → MXR Micro Amp + (front-end boost/EQ) → Boss DD-3 Digital Delay → Signal split to Diezel VH4 / Marshall Super Bass / Bogner Uberschall + Rivera Knucklehead → Mesa 4x12 and Marshall 4x12 (V30s or Greenbacks) → Leslie cabinet mic'd in stereo
The notes are not technically extreme, but locking the syncopated drop-D figure to Danny Carey's shifting subdivisions and keeping mute control clean is the real challenge.
Every song already dialed in for the Line 6 Helix Floor.
Line 6 Helix Floor presets