TOOL · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Drop D, bridge ProBucker into the DSL40CR Ultra channel OD1 for thick mid-forward saturation. Keep gain moderate so each note stays defined. No boost or delay pedal available, so EQ and picking do the tightening.
Loses the rhythmic quarter-note shimmer that opens space between the riff's beats.
Workaround: Play the riff tight and let open strings ring; the dry amp still carries the part.
Less front-end tightening and treble shaping, so palm mutes are slightly looser.
Workaround: Lower amp gain and raise presence/middle to recover attack; pick harder near the bridge.
No stereo swirl or width under the dry amp tracks.
Workaround: Accept a mono dry tone; the swirl was low in the mix anyway.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom Silverburst (bridge humbucker) → MXR Micro Amp + (front-end boost/EQ) → Boss DD-3 Digital Delay → Signal split to Diezel VH4 / Marshall Super Bass / Bogner Uberschall + Rivera Knucklehead → Mesa 4x12 and Marshall 4x12 (V30s or Greenbacks) → Leslie cabinet mic'd in stereo
The notes are not technically extreme, but locking the syncopated drop-D figure to Danny Carey's shifting subdivisions and keeping mute control clean is the real challenge.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings