TOOL · settings for Epiphone Les Paul Standard + Marshall CODE 25
Quarter notes at ~147 BPM (~408 ms), feedback low (2-3 repeats), level ~25%.
Slow rate, depth low, mix ~15%.
Light amount, used as a clean front-end boost.
Drop-D Pneuma riff on the CODE 25: JVM-style high gain with a big mid push, bridge ProBucker, tight bass, plus a quarter-note delay for the rhythmic shimmer and a touch of chorus for Leslie-ish width.
Loses the wide stereo rotary swirl under the dry amps
Workaround: Low-mix slow chorus on the amp gives some motion in mono
Slightly less front-end tightening and treble shaping
Workaround: Amp compressor block plus middle/treble lifted on the panel
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom Silverburst (bridge humbucker) → MXR Micro Amp + (front-end boost/EQ) → Boss DD-3 Digital Delay → Signal split to Diezel VH4 / Marshall Super Bass / Bogner Uberschall + Rivera Knucklehead → Mesa 4x12 and Marshall 4x12 (V30s or Greenbacks) → Leslie cabinet mic'd in stereo
The notes are not technically extreme, but locking the syncopated drop-D figure to Danny Carey's shifting subdivisions and keeping mute control clean is the real challenge.
Every song already dialed in for the Marshall CODE 25.
Marshall CODE 25 settings