Killswitch Engage · settings for Epiphone Les Paul Standard + Blackstar ID:Core 20 V3
No effects needed for this part.
Drop-C metalcore chug on a 20W modeling combo: OD2 voice, bridge ProBucker, gain just past the sweet spot with ISF mid-American for tight scooped-but-present chug. No reverb, no delay \u2014 dry and tight like the record.
Without a drive in front, low C palm mutes lose tightness and bloom slightly.
Workaround: Lower amp bass to 4 and gain to 6.5, pick closer to the bridge, and mute hard with the palm edge.
High-gain hum rings out between palm-muted stabs, blurring the rhythmic gaps.
Workaround: Mute strings with the fretting hand and palm immediately after each stab; keep guitar volume at 10 but stand away from the amp.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Caparison PLM-3 / Dellinger (bridge humbucker) → Maxon OD808 → Boss NS-2 → Framus Cobra 100W → Mesa/Boogie 4x12 Celestion V30 → (layered) Peavey 5150 into VHT 4x12 P50E
Rhythmically straightforward, but the tone depends on very consistent muting and picking accuracy to stay tight at high gain.
Every song already dialed in for the Blackstar ID:Core 20 V3.
Blackstar ID:Core 20 V3 settings