Killswitch Engage · settings for Epiphone Les Paul Standard + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Reverb · Tremolo Speed · Tremolo Intensity
No effects needed for this part.
A Twin Reverb with no pedals cannot make metalcore distortion. Set a loud, tight clean platform with the Vibrato channel, bridge ProBucker full up, and treat this as an approximation until a high-gain distortion pedal is added.
Without it the part is a clean strum, not a metalcore riff.
Workaround: Push amp volume to 7+ for mild breakup and pick hard; accept a dirty-clean approximation.
Low end stays looser and the front end less focused.
Workaround: Roll bass to 3-4 and mute aggressively at the bridge to tighten the chug.
Hum and string noise between stabs will ring out.
Workaround: Palm and fretting-hand muting to silence gaps.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Caparison PLM-3 / Dellinger (bridge humbucker) → Maxon OD808 → Boss NS-2 → Framus Cobra 100W → Mesa/Boogie 4x12 Celestion V30 → (layered) Peavey 5150 into VHT 4x12 P50E
Rhythmically straightforward, but the tone depends on very consistent muting and picking accuracy to stay tight at high gain.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings