Killswitch Engage · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Ultra Gain channel, OD2 mode on the DSL40CR for the drop-C chorus chug. Bridge ProBucker full up, tight bass, strong presence/resonance. No boost pedal owned, so gain is set slightly higher and bass trimmed to keep the riff tight.
Without the front-end boost the low end is looser and palm mutes less focused.
Workaround: Lower bass to 4 and keep gain at 6 rather than maxed; pick closer to the bridge for attack.
High-gain hum rings out between palm-muted stabs.
Workaround: Mute with the picking-hand palm and left-hand fingers; roll bridge volume back between phrases.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Caparison PLM-3 / Dellinger (bridge humbucker) → Maxon OD808 → Boss NS-2 → Framus Cobra 100W → Mesa/Boogie 4x12 Celestion V30 → (layered) Peavey 5150 into VHT 4x12 P50E
Rhythmically straightforward, but the tone depends on very consistent muting and picking accuracy to stay tight at high gain.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings