Killswitch Engage · settings for Epiphone Les Paul Standard + Orange Crush 20RT
At zero: Clean Volume · Reverb
No effects needed for this part.
High-gain drop-C chug on a 20W solid-state Orange: Dirty channel, bridge ProBucker, gain high but not maxed for note definition, treble up for pick attack, bass trimmed so the small speaker stays tight. No reverb, as on the record.
Low end is looser and the attack less focused without a drive pedal tightening the amp front end.
Workaround: Lower amp bass to around 4 and pick nearer the bridge; keep guitar volume at 10 and gain below max for definition.
High-gain hum rings between palm-muted stabs instead of cutting off cleanly.
Workaround: Mute with the picking-hand palm and fretting-hand fingers; keep gain moderate to limit noise.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Caparison PLM-3 / Dellinger (bridge humbucker) → Maxon OD808 → Boss NS-2 → Framus Cobra 100W → Mesa/Boogie 4x12 Celestion V30 → (layered) Peavey 5150 into VHT 4x12 P50E
Rhythmically straightforward, but the tone depends on very consistent muting and picking accuracy to stay tight at high gain.
Every song already dialed in for the Orange Crush 20RT.
Orange Crush 20RT settings