Killswitch Engage · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
JCM800 into the High input with the preamp pushed hard gets a tight, midforward take on the Framus/5150 sound. Bridge ProBucker, full volume and tone, right hand does the tightening since there's no OD808 out front.
Without a boost the low end is looser and the JCM800 lacks the focused metalcore chug.
Workaround: Preamp near max, bass dialled back to 4, and very consistent palm muting at the bridge.
Cranked JCM800 hiss and hum ring out between palm-muted stabs.
Workaround: Mute with the fretting hand and palm, and keep the guitar off-axis from the cab.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Caparison PLM-3 / Dellinger (bridge humbucker) → Maxon OD808 → Boss NS-2 → Framus Cobra 100W → Mesa/Boogie 4x12 Celestion V30 → (layered) Peavey 5150 into VHT 4x12 P50E
Rhythmically straightforward, but the tone depends on very consistent muting and picking accuracy to stay tight at high gain.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings