Slayer · settings for Epiphone Les Paul Standard + Blackstar ID:Core 20 V3
No effects needed for this part.
JCM800 thrash tone on a 20W modeling combo: OD2 voice, ISF pushed British for the mid-forward bite, bridge ProBucker full up, all ambience off for a dry, tight chug.
Less front-end push and mid-hump punch than the original riff tone.
Workaround: Set ISF near British and keep bass low to emulate the mid-hump; bridge volume full for front-end drive.
Hiss and hum ring between muted bursts.
Workaround: Mute with the palm and left hand between bursts; lower gain slightly to reduce noise.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
B.C. Rich (Bich/Mockingbird) with DiMarzio Super Distortion, bridge pickup → Boss 10-band graphic EQ (mid-boosted) → Noise gate → Marshall JCM800 2203 head → Marshall 1960 4x12 cabinet
The notes are simple, but the riff demands clean, even tremolo picking and disciplined muting for the full section without the right hand tiring or the tone washing out.
Every song already dialed in for the Blackstar ID:Core 20 V3.
Blackstar ID:Core 20 V3 settings