Slayer · settings for Epiphone Les Paul Standard + Fender Frontman 10G
No effects needed for this part.
Slayer's cranked JCM800 crunch squeezed into a 10W solid-state Frontman: overdrive switch on, gain high, treble up, bass pulled back so the Epiphone bridge humbucker stays tight. Expect buzzier, smaller saturation but keep the mid-forward, dry character.
No mid-hump boost, so the riff lacks front-end push and midrange punch.
Workaround: Run treble high and bass low, pick hard, and use bridge pickup at full volume for mid bite.
Hiss and feedback ring out between tremolo bursts.
Workaround: Mute with the picking-hand palm and left-hand fingers during rests.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
B.C. Rich (Bich/Mockingbird) with DiMarzio Super Distortion, bridge pickup → Boss 10-band graphic EQ (mid-boosted) → Noise gate → Marshall JCM800 2203 head → Marshall 1960 4x12 cabinet
The notes are simple, but the riff demands clean, even tremolo picking and disciplined muting for the full section without the right hand tiring or the tone washing out.
Every song already dialed in for the Fender Frontman 10G.
Fender Frontman 10G settings