Slayer · settings for Epiphone Les Paul Standard + Marshall MG30GFX
At zero: FX Level · Reverb
No effects needed for this part.
OD2 on the MG30GFX with a mid-forward EQ and tight bass gives the closest JCM800 chug. Bridge ProBucker full up, no reverb, no modulation. Expect solid-state fizz instead of cranked power tubes, so keep gain lower than you'd think.
Less front-end gain and less focused upper-mid punch than the record.
Workaround: Push Middle to 7.5 and cut Bass to 4 on the amp to imitate the mid-hump.
Hiss and bloom between tremolo bursts and chug stops.
Workaround: Mute with the palm and fretting hand; back gain down slightly for quieter gaps.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
B.C. Rich (Bich/Mockingbird) with DiMarzio Super Distortion, bridge pickup → Boss 10-band graphic EQ (mid-boosted) → Noise gate → Marshall JCM800 2203 head → Marshall 1960 4x12 cabinet
The notes are simple, but the riff demands clean, even tremolo picking and disciplined muting for the full section without the right hand tiring or the tone washing out.
Every song already dialed in for the Marshall MG30GFX.
Marshall MG30GFX settings